HP XC System Software 3.2.1 ユーザーズマニュアル
server blades do not have three NICs, and therefore, half-height server blades are not included
in this example
in this example
Because NIC1 and NIC3 on a full-height server blade are connected to interconnect bay 1, you
must use VLANs on the switch in that bay to separate the external network from the
administration network.
must use VLANs on the switch in that bay to separate the external network from the
administration network.
Also, in this example, PCI Ethernet cards are used in the non-blade server nodes. If the hardware
configuration contains non-blade server nodes, see
configuration contains non-blade server nodes, see
for information on which
port to use for the external network.
Figure 2-8 External Network Connections: Full-Height Server Blades and NIC1 and NIC2 in Use
NIC 1
NIC 2
NIC 3
NIC 4
NIC 2
NIC 3
NIC 4
MEZZ 1
MEZZ 2
MEZZ 3
MEZZ 2
MEZZ 3
iLO2
NIC 1
NIC 2
NIC 2
MEZZ 1
MEZZ 2
MEZZ 2
iLO2
Interconnect bay 1
Interconnect bay 2
Interconnect bay 3
Interconnect bay 4
Interconnect bay 5
Interconnect bay 6
Interconnect bay 7
Interconnect bay 8
ONBOARD
ADMINISTRATOR
MGT
NIC
PCI SLOT
PCI SLOT
PCI SLOT
NIC
Non-Blade Server
C-Class Blade Enclosure
Admin ProCurve 2800 Series Switch
Console ProCurve 2600 Series Switch
Gigabit Ethernet Interconnect Switch
MGT
NIC
PCI SLOT
PCI SLOT
PCI SLOT
NIC
Non-Blade Server
ADMIN VLAN
EXTERNAL VLAN
External Public Network
E
D
AL
B
T
H
GI
E
H
LL
UF
E
D
AL
B
T
H
GI
E
H
FL
A
H
Ethernet PCI Cards
2.6.2 Configuring the External Network: Option 2
assumes that NIC1 and NIC2 are already in use for the administration and
interconnect networks. This situation requires a third NIC for the external network, but unlike
, this hardware configuration includes half-height server blades. Therefore,
to make another Ethernet NIC available, you must add an Ethernet card to mezzanine bay 1 on
each server blade that requires an external connection. You must also install an Ethernet
interconnect module in interconnect bay 3 for these cards.
each server blade that requires an external connection. You must also install an Ethernet
interconnect module in interconnect bay 3 for these cards.
In addition, PCI Ethernet Cards are used in the non-blade server nodes. If the hardware
configuration contains non-blade server nodes, see
configuration contains non-blade server nodes, see
for information on which
port to use for the external network.
42
Cabling Server Blades