Hoshizaki C-100BAF 73180 ユーザーズマニュアル
41
7) Grasp the top of the auger and move the
auger towards you and then try to insert a
.02" round stock or pin gauge in between
the back side of the auger shaft and the
bearing surface. See Fig. 11. Check several
locations around the auger shaft. If the
gauge goes between the shaft and the
bearing at any point or if the bearing is
scratched or cracked, both the top bearing
in the extruding head and the lower
bearing in the housing should be replaced.
Instructions for removing the extruding
head and housing are located later in this
procedure.
Note: Replacing the bearing requires a bearing press adaptor. If one is not available,
.02" round stock or pin gauge in between
the back side of the auger shaft and the
bearing surface. See Fig. 11. Check several
locations around the auger shaft. If the
gauge goes between the shaft and the
bearing at any point or if the bearing is
scratched or cracked, both the top bearing
in the extruding head and the lower
bearing in the housing should be replaced.
Instructions for removing the extruding
head and housing are located later in this
procedure.
Note: Replacing the bearing requires a bearing press adaptor. If one is not available,
replace the entire extruding head and housing.
8) Replace the removed parts and panels in the reverse order of which they were removed.
9) Plug the unit into the electrical outlet, then move the power switch to the "ON" position
9) Plug the unit into the electrical outlet, then move the power switch to the "ON" position
to start the automatic icemaking process.
1. Upper Bearing Wear Check
To ensure that the bearing inside the extruding head does not exceed the wear tolerance
of .02", follow the instructions below.
of .02", follow the instructions below.
1) Move the power switch to the "OFF" position, then unplug the unit from the electrical
outlet.
2) Remove all ice from the storage bin.
3) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out
3) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out
the bottom of the door slightly, then gently remove the door from hinge (A). See Fig. 10.
4) Remove the top panel.
5) Remove the spout.
6) Remove the cutter.
5) Remove the spout.
6) Remove the cutter.
Auger
.02" Round Stock or Pin Gauge
Extruding Head
Fig. 11
Hinge (A)
Hinge Stop Pin
Hinge (B)
Fig. 10
Top Panel
Spout
Cutter