Hitachi 3300MFP ユーザーズマニュアル
28 2 Getting started
EN
Installing a print cartridge
To install a print cartridge, use the following steps:
CAUTION
To prevent damage to the print cartridge, do not expose it to light for
more than a few minutes.
more than a few minutes.
1
Make sure the print cartridge door is open.
2
Remove the print cartridge from its packaging, and locate the
sealing tape at the end of the cartridge.
sealing tape at the end of the cartridge.
3
To remove the sealing tape from the cartridge, grasp the tape and
pull it straight out from the cartridge. Avoid touching any black toner
on the tape.
pull it straight out from the cartridge. Avoid touching any black toner
on the tape.
4
Insert the cartridge as shown, with the arrows pointing into the
product.
product.
5
Close the print cartridge door. The print cartridge engages when
the door is closed.
the door is closed.
Note
If toner gets on your clothing or other fabric, wipe off the toner with a dry
cloth. Wash the items in cold water and air dry.
cloth. Wash the items in cold water and air dry.
CAUTION
Hot water or heat from a dryer can set toner into fabric.
Hewlett-Packard Company cannot recommend the use of non-HP print
cartridges, either new, refilled, or remanufactured. Since they are not
HP products, HP cannot influence their design or control their quality.
cartridges, either new, refilled, or remanufactured. Since they are not
HP products, HP cannot influence their design or control their quality.
4
2
3
1
5