Henny Penny 6 ユーザーズマニュアル

Installation

Refer to the following pages for important information regarding the
installation of LCS and LCG ClimaPlus Combis. It is recommended 
that installation be accomplished by a certified and properly trained 
technician.

NOTE: When installing a ClimaPlus combi, humidity calibration must
be performed. This process takes approximately 45-60 minutes. (page 62)

Site, leveling

1) Check for any transport damages. Should there be any signs of transport 

damage immediately inform your dealer/freight forwarder.

2) Check installation site. Check entrance clearance.

Minimum entrance space needed without pallet: 

Model 6 & 10:

35

1

⁄

2

in. (902 mm)

Model 1020:

49

5

⁄

8

in. (1262 mm)

Model 20:

39

7

⁄

8

in. (1012 mm)

Model 40:

52

1

⁄

2

in. (1332 mm) 

■

Floor at installation site must be level. 

■

Cold water line in place. (page 63)

■

2 in. (50 mm) drain connection installed.

■

Max. drain height for floor units: 4 in. (100mm)

■

Electrical power supply/protective measures installed and sized correctly. 
(page 60-61) 

3) Remove all cartons, packing materials, documents etc. from the interior cabinet.
4) Remove grid shelves/trolley from cabinet.
5) Take unit off the pallet.

■

Moving unit without pallet: Sizes 6, 10, 1020 (Fig. 1)

■

Moving unit without pallet: Sizes 20, 40 (Fig. 2)

Minimum clearance sides and back:
2 in. (50 mm)

Service clearance, left side:
20 in. (500 mm)

Clearance for door opening:

Model 6 & 10:

20

1

⁄

2

in. (521 mm)

Model 1020:

29

1

⁄

2

in. (749 mm)

Model 20:

28

3

⁄

4

in. (730 mm)

Model 40:

30

3

⁄

4

in. (781 mm)