Harbor Freight Tools 42619 ユーザーズマニュアル

Page 3

SKU 42619 

        

Locate the Main Wing and Fuselage.  

1. 

Remove the tape covering on the center 

of the Fuselage.  Adhere the Wing to the 

Fuselage making sure that the center of 

the Wing lines up with the center of the 

Fuselage.  Use a small pin or apply slight 

pressure to hold the wing in place until 

the adhesive is tightly in place.

2.  Peel off the cover from the two small 

pieces of adhesive tape on the underside 

of both wings.  Adhere the two Wing 

Supports to the Wing-see Figure 1.

3.  Peel off the covering from the adhesive 

tape located on the bottom side of the 

Fuselage Tail.  Making certain that the 

mid point of the Stabilizer is lined up with 

the midpoint of the Fuselage, attach the 

Horizontal Stabilizer to the Fuselage-see 

Figure 2.

4.  While squeezing the legs of the Landing 

Gear together,  insert legs into the slot 

on the bottom of the Fuselage.  After 

the Landing Gear is inserted, release 

pressure on the Landing Gear Legs so 

that they snap into place and are held in 

their slot on the Fuselage-see Figure 3.

5.  Plug the Propeller Spinner set on the 

Motor.  Make certain that the Propeller 

fits tightly on the Motor Shaft-see Figure 

4.

If the temperature is lower than 55° F, 

1. 

warm the battery by holding it or bringing 

it indoors to a warmer temperature 

before charging.  Do not heat the battery 

with a flame.
If the battery is hot or warm from 

2. 

previous use, allow it to cool to room 

temperature before charging.
Insert two ‘AA‘ batteries into the charger. 

3. 
CAutiOn!  position batteries in proper