GoVideo DP 5050 ユーザーズマニュアル

29

•  Hold the disc by the edges 

so the surface will not be 

soiled with fingerprints.

•  Fingerprints, dirt and 

scratches can cause 

skipping and distortion.

•  Do not write on the label 

side with a ball-point pen or 

other writing utensil.

•  Do not use record cleaning sprays, benzine, 

thinner, static electricity prevention liquids, or 

any other solvent.

•  Be careful not to drop or bend the disc.

•  Do not install more than one disc on the disc 

tray.

•  Do not try to close the disc cover when the disc 

is not installed properly. 

•  Be sure to store the disc in 

its original case when not in 

use.

•  Wipe gently with a soft, 

damp (water only) cloth.

•  When wiping discs, always 

move the cloth from the 

center hole toward the outer 

edge. (If you wipe the disc 

using a circular motion, 

circular scratches are likely 

to occur, which will cause 

noise.)

•  Wipe moisture off with a soft, dry, lint-free cloth 

before using the disc.

You can damage discs if you store them in the 

following places:

•  Areas exposed to direct sunlight

•  Humid or dusty areas

•  Areas directly exposed to a heat outlet or 

heating appliance

•  CD-ROM (Application Program)

•  CVD

•  CD-G

•  DVD with a Region Code other than that 

shown on the DVD unit’s Region Code Label 

on the rear panel

•  Be sure to turn the unit off and disconnect the 

AC power cord before maintenancing the unit.

•   Wipe this unit with a dry soft cloth. If the 

surfaces are extremely dirty, wipe clean with a 

cloth which has been dipped in a weak soap-

and-water solution and wrung out thoroughly, 

and then wipe again with a dry cloth.

•  Never use alcohol, benzine, thinner, cleaning 

fluid or other chemicals. And do not use 

compressed air to remove dust.