GM Gasoline V6 90 Degree ユーザーズマニュアル

ページ / 94
ENGINE APPLICATION MANUAL
GM Powertrain
Gasoline 4.3L V6 90 Degree
Revised: 08/15/2000
File: c:\data\manuales\v6-truck\am43v6#3.doc
Contact:Luis Nespolo - (248) 857-1558
Printed: 8/15/00
48
Engine  Pre Heather
P-Truck
C/K Truck
G-Van
M/L -Van
S/T Truck
( 6Y  2C )
Pre Heather ASM
12556261
12556261
12556261
12556261
12556261
Screw/Bolt
15969147
15969147
15969147
15969147
15969147
11509126
11509126
11509126
11509126
11509126
11515763
11515763
11515763
11515763
11515763
Cord ASM
52353022
52353022
52353022
52353022
52353022
15726112
15726112
15726112
15726112
15726112
Strap
15517469
15517469
15517469
15517469
15517469
3.2.3 GMPT interface with CHASSIS BRAKE ABS System
Figure 3.2.1-I to 3.2.1-XVIII shows the PCM Engine to Vehicle Mechanization Diagram with this
interface.
L35
Motor
PG260
Current Drain
312 Amps
Power Rating Kw
1.4Kw
Motor Drive
Engagement Type
Solenoid Actuated
Positive Engagement
Gear Reduction Type
Pinion Engages From:
Front
3.2.2 GMPT interface with Electrical Starting System
The following table shows the different Starters and Components coupled to the L35 engine and
GM platforms.
• Ignition voltage to PCM must be maintained at or above 7 volts during cranking.
• The operation of the 4.3L V6 90 Degree Engine System shall not adversely affect any of the
vehicle electrical subsystems.
• Conversely, the operation of any vehicle electrical subsystem shall not adversely affect the
operation of the 4.3L V6 90 Degree Engine System.
• Before performing any welding, disconnect negative battery cable and PCM connectors to
avoid damage to other systems components.
• All engine electrical systems and controllers are not to exceed the allowable levels of radiated
electromagnetic emissions described in specification GM 9114P dated December 14, 1994.
• Engine Electric Wiring Harness Including Connections Provisions For:
Battery, Grounding Requirements, Mounting (Wiring Retention for Function and
Appearance),
Starter, Alternator, Sensors and Switches, Thermal Environment, IP Signal
Information, Oil Life, Monitoring, Oil Level Sensing, PCM & Governor Wiring Assembly.
• All Electrical Connector Insertion Forces Less than 80 Newton’s.
• The electrical generator assembly is not part of the engine scope of supply.
The following table shows the different Pre-Heaters and Components coupled to the L35 engine
and GM platforms.
Engine  Starter
P-Truck
C/K Truck
G-Van
M/L -Van
S/T Truck
( 6 Y  2 )
Starter ASM
12563829
12564107
12564107
12564107
12564107
Shield
12561327
12561327
12561327
12561327
12561327
Bolt/Screw
12561387
12561387
12561387
12561387
12561387
12555162
12555162
12555162
12555162
12555162
1246249
1246249
1246249
1246249
1246249