Extron electronic Extron Electronics GPS Receiver VM 700T ユーザーズマニュアル

The Extron

®

 VM 700T is 

an adapter that provides a 

VESA‑mounting option for the 

TLP 700TV TouchLink

™

 panel.

Four holes, one in each corner 

allow the adapter to fit any third‑party VESA Type D 75 mm mounting kit.
This guide provides basic instructions for an experienced installer to mount and 

perform initial configuration on the TLP 700TV.
 

 

The TLP 700TV comes assembled with a stand that allows it to be placed on a desk‑top.  The stand can also be 

removed and replaced with the Extron VM 700T VESA mount adapter kit (part # 70‑692‑01).  This kit fits into any 

third‑party VESA Type D 75 mm wall mount system as follows:
1.

  Determine the best location for wall‑mounting the TLP 700TV.

  Follow the manufacturer’s instructions to attach the VESA mounting kit to the wall.

W

  Run the cables for power, LAN, and video (two BNC connectors) to the installation site. 

  Remove the TLP 700TV from its packaging or, if the TLP 700TV has previously been used as a free‑standing, 

desk‑top unit, remove all cables to the back of the base.

At the bottom, the two plastic cover plates for the 

stand are held together by a Phillips head screw 

near the base. Remove the screw in the recessed slot 

at the front of the stand, close to the base.

  At the top, the two plastic plates covering the stand 

are held together by four locking tabs on the back 

cover plate fitting into four slots on the front cover 

plate.  Squeeze the sides of the front plate at the top 

so that the tabs are no longer seated in the slots.

68-1792-01

Rev. A 08 09