Epson V7 ユーザーズマニュアル

4. Select the PLC model to be connected at 

the MJ port.  Click the [Setting] button.  
The [Type Setting] dialog is displayed.  
Select [PLC2Way].  The PLC manufacturer 
names who support PLC2Way 
communication are displayed.  Click [+].  
The available model names of the selected 
manufacturer are displayed.  Select the 
PLC model name and click [OK].  The 
message communication “Communication 
parameters are reset.  OK?” is displayed.
Click [Yes].

5. Set the parameters for the PLC to be connected at the MJ port.

[Baud Rate] (4800, 9600, 19200, 38400, 57600, 115000, 115 kbps)

Select the communication speed with the PLC connected at the MJ port.

[Parity] (None/Odd/Even)

Select the parity setting for communications with the PLC connected at the MJ port.

[Data Length] (7-bit/8-bit)

Select the data length for communications with the PLC connected at the MJ port.

[Stop Bit] (1-bit/2-bit)

Select the stop bit setting for communications with the PLC connected at the MJ 
port.

[Signal Level] (RS232C/RS485)

Select the signal level for communications with the PLC connected at the MJ port.

[Retrials]

Set the number of retrials to be attempted in the case that a communication error 
occurs.

[Time-out Time] (

×100 msec)

Select the receive time of the response from the PLC connected at the MJ port.  If 
no response is received within the specified time, a retrial is attempted.

[Send Delay Time] (

× msec)

Set a time delay in sending the response to the PLC after receipt of data from the 
PLC connected at the MJ port.