Cyclades AlterPath family of KVM products ユーザーズマニュアル
Installation
101
Enabling Access to the Web Manager without Making a Direct Connection
Enabling Access to the Web Manager without
Making a Direct Connection
Making a Direct Connection
This section describes additional alternatives for enabling access to the Web
Manager that do not require making a direct connection. Both of the two
following approaches require an experienced administrator to configure:
Manager that do not require making a direct connection. Both of the two
following approaches require an experienced administrator to configure:
•
The KVM/net ships with a default IP address: 192.168.160.10. You can
use the default address to bring up the Web Manager, assign a fixed IP
address to the KVM/net and specify other network parameters without
making a direct connection. To do so, you must temporarily change the IP
address of a computer on the same subnet. See “To Use the Default IP
Address to Access the Web Manager” on page 101.”
use the default address to bring up the Web Manager, assign a fixed IP
address to the KVM/net and specify other network parameters without
making a direct connection. To do so, you must temporarily change the IP
address of a computer on the same subnet. See “To Use the Default IP
Address to Access the Web Manager” on page 101.”
•
DHCP is enabled on the KVM/net by default. If you have network access
to the DHCP server for the KVM/net, and if you are able to discover the
KVM/net’s dynamically assigned IP address, you do not need to make a
direct connection. Discovering the current IP address requires entering the
KVM/net’s MAC address. Make a note of the MAC address, which is on a
label at the bottom of the unit in the form NN-NN-NN-NN-NN-NN, and go
to “To Use a Dynamic IP Address to Access the Web Manager” on
page 102.”
to the DHCP server for the KVM/net, and if you are able to discover the
KVM/net’s dynamically assigned IP address, you do not need to make a
direct connection. Discovering the current IP address requires entering the
KVM/net’s MAC address. Make a note of the MAC address, which is on a
label at the bottom of the unit in the form NN-NN-NN-NN-NN-NN, and go
to “To Use a Dynamic IP Address to Access the Web Manager” on
page 102.”
T
To Use the Default IP Address to Access the
Web Manager
Web Manager
The default IP address for the KVM/net is 192.168.160.10. This
procedure assumes that you are able to temporarily change the IP address of a
computer that is on the same subnet as the KVM/net.
procedure assumes that you are able to temporarily change the IP address of a
computer that is on the same subnet as the KVM/net.
1. Set up the AlterPath KVM/net.
2. Connect computers and other devices to be managed through the KVM/
net.
3. Power on the KVM/net and connected devices.