CyberResearch CPBH ユーザーズマニュアル
CyberResearch
®
CPU Cards
CPBH Series
CyberResearch, Inc.
7
25 Business Park Drive
P: (203) 483-8815; F: (203) 483-9024
Branford, CT USA
www.cyberresearch.com
Chapter 3
Hardware Installation
This chapter provides the information on how to install the hardware
using the CPBH. This chapter also contains information related to
jumper settings of switch, watchdog timer selection, etc.
using the CPBH. This chapter also contains information related to
jumper settings of switch, watchdog timer selection, etc.
3.1 Before
Installation
After confirming your package contents, you are now ready to install
your hardware. The following are important reminders and steps to
take before you begin with your installation process.
your hardware. The following are important reminders and steps to
take before you begin with your installation process.
1.
Make sure that all jumper settings match their default settings
and CMOS setup correctly. Refer to the sections on this chapter
for the default settings of each jumper. (Set JP3 1-2)
and CMOS setup correctly. Refer to the sections on this chapter
for the default settings of each jumper. (Set JP3 1-2)
2.
Go through the connections of all external devices and make
sure that they are installed properly and configured correctly
within the CMOS setup. Refer to the sections in this chapter for
the detailed information on the connectors.
sure that they are installed properly and configured correctly
within the CMOS setup. Refer to the sections in this chapter for
the detailed information on the connectors.
3.
Keep the manual and diskette in good condition for future
reference and use.
reference and use.
4.
Make sure your power supply is you use is for P4 only. One of
4-pin connectors is for +12V lead which should be connected
to CN1 connector of the CPBH.
4-pin connectors is for +12V lead which should be connected
to CN1 connector of the CPBH.