CTC Store IPDSLAM-A8/A16 ユーザーズマニュアル

 
 

                                                                 

 

111 

This section describes how to upgrade the software of your ADSL IP DSLAM.   

Step 1: connect your PC with the UPLINK port of ADSL IP DSLAM by using an 

Ethernet cable. 

Step 2: Prepare an new ADSL IP DSLAM software (filename, IP16s_TFTP_ 

V243_DLINK.BIN, is taken as an example here) and the TFTP utility. 

Step 3: Extract the TFTP utility, “tftp.zip”, into one directory of your PC. 

Step 4: Rename the filename “IP16s_TFTP_ V243_NoBrand.BIN” as “ipam” 

and put into the same directory with TFTP.   

Step 5: Log in CLI by using a RS-232 cable and type the command” sysip” to 

access the IP address of ADSL IP DSLAM. (This step can be skipped 
if the IP address of ADSL IP DSLAM has been available).   

Step 6: Activate the “MS-DOS mode” and enter the directory that you made for 

TFTP utility. 

Step 7: Key in the following command to upgrade your ADSL IP DSLAM: 

C:\TFTP\tftputil 192.168.100.111 put adsl   

 
C:\TFTP \tftputil 192.168.100.111 put ipam 
Transfer successful: 8 bytes in 1 second, 8 byte/s 
Transfer successful: 2097152 bytes in 91 seconds, 23045 byte/s 
C:\TFTP\tftputil 
C:\TFTP\tftputil 
 

Step 8: After entering this command, ADSL IP DSLAM will be processing 

upgrade immediately. When ADSL IP DSLAM is upgrading, LED, 
“MAINT” “ALARM” and “FAULT”, will be blinked. It takes 20 seconds to 
complete upgrade if there is no power off during the procedure. 

Step 9: Once those 3 LEDs stop blinking, the software upgrade is completed 

and ADSL IP DSLAM will restart automatically. 

Step 10: Enter ADSL IP DSLAM CLI again and type the command, “show 

sysinfo” to verify the software version. The version shall be “2.43”