Crown Audio MA-5002VZ ユーザーズマニュアル

Typical input and output wiring is shown in 
Figure 3.8.

INPUTS: Connect input wiring to Channel 1. 
Refer to Figure 3.4 for input connector pin 
assignments.

OUTPUTS: Install a jumper wire between the 
positive outputs of both Channel 1 and Channel 
2 that is at least 14 gauge in size; Connect  posi-
tive (+) speaker lead  to Channel 1 positive 
output of amp; connect negative (-) speaker lead  
to Channel 2 negative output of amp. Refer to 
Section 3.5 for output connector pin assign-
ments. Make sure the Mode switch is set to the 
“Parallel” position when operating in Parallel-
Mono mode.

NOTE: Turn down (full CCW) the Channel 
2 level control when operating in
Parallel-Mono mode, as the lower-
numbered level control works both
channels.

NOTE: Crown provides a reference of wiring pin 
assignments for commonly used connector 
types in the Crown Amplifier Application Guide 
available at www.crownaudio.com.