Crestron electronic CEN-iServer ユーザーズマニュアル

Crestron CEN-ISERVER 

 

Crestron iServer™ Network Audio Server

Make the necessary connections as called out in the illustration that follows this 
paragraph. Refer to “Network Wiring” on page 9 before attaching the 4-position 
terminal block connector. Apply power after all connections have been made. 

When making connections to the CEN-ISERVER, note the following: 

•  Use Crestron power supplies for Crestron equipment. 
•  The included cable cannot be extended. 

 

NOTE:  For CAT5 connections use Crestron Certified Wire. 

NOTE:  Ensure the unit is properly grounded. 

NOTE:  Due to the bandwidth limitations of a LAN, the CEN-ISERVER is not 
recommended for loading an empty iPod with a large music/video library. A direct 
USB connection between the iTunes PC and the iPod is highly recommended when 
loading an empty iPod with a large music/video library. After the iPod is loaded, the 
CEN-ISERVER should be used for regular syncing operations. 

NOTE:  Prior to connecting the iPod, the iPod’s TV Out setting must be set to On 
the TV Screen setting must be set to the aspect ratio of the connected display (16:9 
or 4:3), the TV Signal setting must be set (NTSC or PAL), and the Fit to Screen 
setting must be set to Off. For instructions, refer to the iPod instruction manual. 

After all the connections have been made to the CEN-ISERVER, the iPod can be 
connected to the CEN-ISERVER. To connect the iPod: 

1.  Open the docking bay by loosening the thumbscrews and sliding the 

docking bay forward. 

2.  As shown in the following diagram, connect the iPod to the docking cable 

located inside the docking bay. The symbol on the interface cable connector 
must face up as shown. 

•  11