Funai TB110MW9 ユーザーズマニュアル

ページ / 32
7
EN
Before Usin
g
Information on Digital Broadcasting
Digital terrestrial 
antenna
Digital
terrestrial signals
STB (Set Top Box) 
converts the ATSC signal 
to analog signal
TV
Receives 
ATSC
ATSC
This STB makes it possible to view the digital TV 
programs on your analog TV by converting the 
digital signal to the analog signal. You can use 
most features provided by the digital broadcast, 
except that the resolution of the image is always 
output in 480i (standard resolution).
Accessories
Check the following accessories when unpacking the STB:
Remote control: 
NA386UD (x1)
Owner’s manual:
1VMN25977 (x1)
AA battery (1.5V) x 2
RF cable: 
WPZ0901TM002 / 
WPZ0901TM005 (x1)
Installing Batteries
Instalación de pilas
1   Unsnap the battery cover from the
back of the remote control.
Abra la cubierta de pilas de la parte 
trasera del mando a distancia.
2   Install two AA batteries making
sure the polarity (+ / - ) is correct.
 
 Instale dos pilas AA asegurándose que 
la polaridad (+ / - ) sea la correcta.
3  
S
Snap the battery
ccover back.
 
 Cierre la cubierta de 
pilas.
CAUTION:
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, 
ni-mh, etc) batteries.
 No mezcle baterías alcalinas, estándar (zinc-carbono) o recargables (ni-cad, ni-mh, etc.).
Do not mix new and old batteries together.
 No mezcle pilas nuevas con antiguas.
Do not recharge, short-circuit, heat, burn or disassemble batteries.
No recargue, caliente, queme o desarme baterías ni provoque un corto circuito 
con ellas.
Remove batteries from battery compartment that is not going to be 
used for a month or more.
Quite las pilas del compartimento de pilas si no se va a utilizar durante un mes o más.
NOTE:
 When replacing batteries,
replace them in pairs.
Cuando cambie las pilas, 
hágalo por pares.
X6043UD_TB110MW_v3.indd   7
X6043UD_TB110MW_v3.indd   7
2010/08/31   11:24:10
2010/08/31   11:24:10