Fujifilm FinePix REAL 3D V3 オーナーマニュアル

For Your Safety

• Do not immerse in or expose to water.
• Cease use immediately should you notice leakage, deformation, 

discoloration, or other abnormalities.

• Insert in the correct orientation.

in the unlikely event of the battery leaking, remove any 
liquid from the battery chamber and insert a fresh battery.

Use only FUJIFILM AC power adapters designated for use with this 
device.  Other adapters could damage the device.
•  The AC power adapter is for indoor use only.
• Be sure the DC plug is securely connected to the device.
•  Turn the device off  before disconnecting the adapter.  Disconnect 

the adapter by the plug, not the cable.

• Do not use with other devices.
• Do not disassemble.
• Do not expose to high heat and humidity.
• Do not subject to strong physical shocks.
• The AC power adapter may hum or become hot to the touch 

during use.  This is normal.

• If the AC power adapter causes radio interference, reorient or 

relocate the receiving antenna.

This device may interfere with hospital or aviation equipment. 
Consult with hospital or airline staff  before using the device in a 
hospital or on an aircraft.

In the event that the monitor is damaged, care should be taken to 
avoid contact with liquid crystal.  Take the urgent action indicated 
should any of the following situations arise:
• If liquid crystal comes in contact with your skin, clean the area with a 

cloth and then wash thoroughly with soap and running water.

• If liquid crystal enters your eyes, fl ush the aff ected eye with clean 

water for at least 15 minutes and then seek medical assistance.

• If liquid crystal is swallowed, rinse your mouth thoroughly with wa-

ter.  Drink large quantities of water and induce vomiting, then 
seek medical assistance.

P iii) and make sure you understand them before using the device.

Perchlorate Material—special handling may apply.  See http://www.dtsc.ca.gov/hazardouswaste/perchlorate.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause 
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired opera-
tion.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment 
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment 
off  and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifi cations not expressly approved in this manual could void the user’s authority to operate 
the equipment.

To comply with Part 15 of the FCC Rules, this product must be used with a FUJIFILM-specifi ed ferrite-core A/V cable, USB cable, and 
DC supply cord.

CAUTION: This Class B digital apparatus complies with Canadian ICES-003.