Contax i4R ユーザーズマニュアル
EN-32
2
Close the lens cover.
Operating the camera after auto off
This camera is fitted with a power-saving auto off function that
automatically turns the camera off if you leave it without performing any
operations.
automatically turns the camera off if you leave it without performing any
operations.
When the auto off function is activated, the LCD
monitor is cleared and the lens is retracted into the camera.
Use the following procedure to operate the camera after the auto off
function has been activated.
function has been activated.
z
When you want to close the lens cover
Slide the lens cover once towards the outer edge until it stops (approximately 2 mm), then close the lens
cover.
cover.
z
When you want to turn the camera on again
Close the lens cover as described above.
Turn the camera back on by following the procedure on p.31.
Turn the camera back on by following the procedure on p.31.
B
Note
You can change the time setting of the auto off function. (Æ p.165)
A
Important
If you close the lens cover directly, there is a risk of damaging the camera.