Contax U4R ユーザーズマニュアル
EN-147
Viewing images on a Macintosh
1
Insert the memory card into the camera.
(Æ p.30)
2
Place the camera in the USB cradle and
connect the AC adapter.
3
Use the USB cable supplied with the camera to connect the
USB cradle to the Macintosh and start the Macintosh.
A
Important
• You do not need to install the USB drivers on a Macintosh computer. Connect the USB
cable without installing the drivers.
• To view images on your Macintosh, you must have image-viewing software already
installed. (To play movies, QuickTime 4.1 or later is required.)
• Always use the AC adapter when you connect the camera to a computer to view and
copy images, etc. If the battery runs out and the camera turns off, files may be
corrupted.
corrupted.
• To view movies that have a large number of pixels or a high frame rate, first copy the
movie to your PC and then play the copy of the movie. If you use your PC to play back a
movie that is stored on a memory card loaded in the camera, the data transfer rate may
be too slow for the movie to play smoothly.
movie that is stored on a memory card loaded in the camera, the data transfer rate may
be too slow for the movie to play smoothly.
A
Important
You cannot view images on the Macintosh unless
there is a memory card in the camera.
there is a memory card in the camera.
B
Note
A
Important
Check the sizes of the USB connectors. Plug the small connector into the USB cradle
and the large connector into the USB port on your Macintosh.
and the large connector into the USB port on your Macintosh.