Compatible Systems 1250I ユーザーズマニュアル
22
Chapter 6 - Basic Configuration Guide
RS-232 (WAN 1) Physical Communications Settings
You may need to set the baud rate, sync/async operation, and other
physical communications parameters for the WAN interface. These
parameters will depend on the line communications device you are
using.
physical communications parameters for the WAN interface. These
parameters will depend on the line communications device you are
using.
v
Note:
Frame Relay is presently supported in the MicroRouter 1250i
only via synchronous operation. An external clock signal is generated
for Frame Relay.
for Frame Relay.
CV: Use the Physical Configuration: WAN 1 Dialog Box.
TB: Use configure and set the LinkType keyword or other keywords
in the RS232 Interface WAN 1 section.
PPP Configuration
This section covers the settings required for PPP (point-to-point)
protocol operation of the WAN interfaces.
protocol operation of the WAN interfaces.
Internal T1 CSU/DSU (WAN 0) Link Configuration
Required for Dedicated Line Operation
This is the only mode of operation supported via the built-in T1
CSU/DSU.
CSU/DSU.
•
Set PPP connection
CV: Use the Link Configuration: WAN 0 Dialog Box.
TB: Use configure and set the Mode keyword in the Link Config
WAN 0 section.
Suggested for Dedicated/Leased Line Operation
Dedicated line operation generally does not require additional parame-
ters for operation.
ters for operation.
RS-232 (WAN 1) Link Configuration
Required for Dedicated/Leased Line Operation
Dedicated line operation is the simplest to set up.
•
Set Dedicated connection
•
Set PPP connection
CV: Use the Link Configuration: WAN 1 Dialog Box.