Cobalt Networks OPENGEAR PS-8300 ユーザーズマニュアル

••••

You must obtain a license key from Cobalt Digital Inc. to enable SNMP support.

Use the following procedure to obtain your license key:

1.  Request a license key from your distributor or at sales@cobaltdigital.com, quoting

the 8-character hardware-ID provided on the page.

2.  Open the Frame Configuration Page for the frame using DashBoard. OR

Point your web browser to the IP address of the frame.

3.  Select the tab titled SNMP Configuration.

If SNMP has not been enabled, this page will ask you to enter a license key.

4.  Enter the license key in the field provided.

5.  Click Submit.

After a valid license key has been entered, the frame displays the SNMP
configuration page.

This completes the procedure to enable the SNMP agent on the frame.

The SNMP agent on the frame will accept SNMP GET and SET requests on the default SNMP port
(161), using SNMP version 1 or SNMP version 2c.  The SNMP commands will send SNMP traps to
one or more notification targets, with user-configurable address, port, and protocol version number.

Use the following procedure to configure your SNMP Agent:

1.  Open the configuration page for the frame using DashBoard. OR

Point your web browser to the IP address of the frame.

2.  Select the tab titled SNMP Configuration.

3.  Set the required parameters as follows:

•

 

Read Community String  



 Enter the SNMP password for GET requests.

•

 



 Enter the SNMP password for SET requests.

4.  To add a trap/notification target, specify the following:

•

 









  Enter the IP address to which traps should be sent.

•

 

Port number 



 Enter the UDP port number to which traps should be sent.

•

 

SNMP version 



  Enter the protocol version to be used for traps to this target.

•

 

Target community string 



  Enter the community string.

5.  Click Add to add the target to the list.

To remove a trap/notification target, select the target in the list,
and click Delete.

6.  Click the Submit button to configure the frame.

This completes the procedure to configure your SNMP Agent.