Classe CT-M600 Monaural ユーザーズマニュアル
11
Front Panel
1
Standby button & LED indicator
The front panel Standby button will toggle the amplifier between operate,
its fully operational state, and a standby mode that leaves the amplifier off,
yet ready to respond to system commands via any of the supported control
options (e.g. IR input, DC trigger, CAN-Bus, or RS-232).
The current state of the amplifier is indicated by the LED indicator in the
Standby
button. The state of this LED indicates the following:
• on (dim red)
= standby
• flashing blue (on power-up) = initialization
• on (blue)
=
operate
•
flashing (after power-up) = AC mains voltage out of range
•
flashing (alternating red/blue) = the air intake filter needs to be cleaned
•
slow flashing red
=
protection circuit(s) engaged
1
CA-M600
CT-M600