FANUC Robotics America GFK-1541B ユーザーズマニュアル

For general information about module and system installation, refer to GFK-0356, Series 90-30
Programmable Controller Installation Manual

.

Make sure you have the items listed below before you begin.

ƒ 

A Series 90-30 PLC CPU baseplate, or any Series 90-30 baseplate and a Series 90-30 CPU
with power supply.

ƒ 

The CMM321 requires CPU version 6.50 or higher for full functionality.  CPU versions
5.03 to 6.04 permit Ethernet operation with only 1 SRTP server connection.

ƒ 

The CMM321 requires PLC power supply IC693PWR321 (Revision K or later),
IC693PWR322, or IC693PWR330.

ƒ 

PLC programming software:  Logic Developer (all versions), Control Version 2.01 or higher,
VersaPro

 version 1.0 or higher, or Logicmaster 90-30 version 6.01 or higher.  (And a

compatible PC-compatible personal computer.)

ƒ 

If you are using the AAUI port instead of the 10Base-T port, you will need an Ethernet-
compatible AAUI transceiver and Ethernet cables.  (See Appendix B for more information on
the ports and transceivers.) Optional

ƒ 

An 

IC693CBL316

 serial cable for the Station Manager port on the Ethernet Interface (see

Appendix B).  Optional

ƒ 

A terminal or IBM-compatible personal computer equipped with terminal emulation
software.  Optional

If your installation requires CE Mark compliance, please refer to GFK-1179,
Installation Requirements for Conformance to Standards

, shipped with the PLC

programming software, for additional guidelines.

A CMM321 can be mounted on a CPU baseplate, an expansion baseplate, or a
remote baseplate.  However, due to power requirements, only two Ethernet
Interface modules are permitted per baseplate using a standard power supply.
Up to four Ethernet Interface modules are permitted per baseplate using a high
capacity power supply.

www.cadfamily.com    EMail:cadserv21@hotmail.com
The document is for study only,if tort to your rights,please inform us,we will delete