FANUC Robotics America GFK-1541B ユーザーズマニュアル

For general information about module and system installation, refer to GFK-0262, Series 90-70
Programmable Controller Installation Manual

.

Make sure you have the items listed below before you begin.

ƒ 

Series 90-70 PLC rack.

ƒ 

Series 90-70 power supply.

ƒ 

To use the AUI port, the power supply must be one of the following types, which
provide +12 Vdc for an external transceiver on the AUI port: IC697PWR711,
IC697PWR724,  or IC697PWR748.

ƒ 

If the AUI port will not be used, +5 Vdc is all that is required.  Under these conditions,
power supply IC697PWR710 is sufficient.

ƒ 

A Series 90-70 CPU.

ƒ 

PLC programming software:  Logicmaster 90-70 version 6.02 or higher or Control version
1.0 or higher (runs on a personal computer).

ƒ 

Ethernet cables and, if using the AUI port, an Ethernet-compatible AUI transceiver.  (See
Appendix B, “Communications Ports Characteristics”, for more information.)

ƒ 

A serial cable for the Station Manager port on the Ethernet Interface (see Appendix B).
Optional

ƒ 

A terminal or IBM-compatible personal computer equipped with terminal emulation
software.  Optional

ƒ 

A Phillips-head screwdriver.

If your installation requires CE Mark compliance, please refer to GFK-1179,
Installation Requirements for Conformance to Standards

, shipped with the PLC

programming software, for additional guidelines.

www.cadfamily.com    EMail:cadserv21@hotmail.com
The document is for study only,if tort to your rights,please inform us,we will delete