Falcon MONITORING F110 ユーザーズマニュアル

www.rletech.com

20

970.484.6510

3

  F110 Web Interface

color based upon where the temperature or humidity is in relation to the established high and 

low thresholds.

If the temperature or humidity is between the high and low thresholds and more than five (5) 

degrees from either threshold, the status icon will be green. If it is within five (5) degrees of the 

high threshold, the status icon will be yellow. If it is within five (5) degrees of the low threshold, 

the status icon will be blue. If the high or low threshold is exceeded, the status icon will be red. 

If no thresholds are currently defined, the status icon will be gray.

The Status screen also displays the current status of any switch sensors connected to the F110. 

If the status icon above the switch sensor is red, then that switch sensor is currently in an alarm 

state. Below the status icon and switch sensor label, the current switch sensor state will be 

displayed. If you are unsure as to which state (i.e. open or closed) to set for the switch sensor 

alarm state and the switch sensor is not currently in an alarm state, set the alarm state to be the 

opposite of what is displayed here. Refer to the manual of each sensor for information on the 

normal state (open or closed) of the switch sensor in use.

Below the DHCP Name and time display are a number of radio buttons and form fields that 

allow the display of the F110 web server interface to be modified. Changing the Display radio 

buttons will toggle how inactive sensors are displayed, modifying the Update Every form field 

will adjust the refresh time of the F110 web server interface and selecting the Celsius radio 

button instead of the Fahrenheit radio button will display sensor values in Celsius.

The F110 Settings Screen is used to modify the F110 configuration. Here users can configure 

Network, Email, SNMP, Alert Threshold, Security, and Advanced settings. When settings are 

modified and saved, the F110 will automatically reset and start with the new configuration.

After you make a field change, click on Accept Changes at the bottom of the screen, then click 

on Save Settings on the left hand column.

You will see an authentication security prompt appear once accessing the Settings Menu. 

Default from RLE, there is no USER name and NO password assigned to the unit. A password 

can be assign to the unit later during the configuration. There is no USER name assigned to the 

unit, at this time.

Figure 3.2 Authentication Security Prompt (no Username or Password)