Avital 5103 オーナーマニュアル

➢

Arming diagnostics

If the security system is armed at the same time that an input is active (such as

a door opening or sensor triggering), you will hear one siren chirp to indicate

arming and a second siren chirp to indicate Bypass Notification.

A Bypass Notification chirp means that the security system ignores the input

that was active when the system was armed, until that input ceases. Three

seconds after that input ceases, the security system will resume normal monitor-

ing. For example, if your vehicle has an interior light exit delay and you arm

your security system before the interior light turns off, you may hear a second

Bypass Notification chirp. Once the light turns off, however, the security system

resumes normal monitoring.

Note: Bypass Notification does not occur when the system is in Silent Mode or

if the notification chirps have been programmed off by the installer.

➢

Disarming diagnostics

Extra chirps that are heard when disarming the system are the Tamper Alert. If

four chirps are heard when disarming the system, then the security system was

triggered in your absence.

If five chirps are heard when disarming the system, a zone was triggered so

many times that the Nuisance Protection

Circuitry has bypassed that zone. In

either case, the status LED will indicate which zone was involved (see Table

of Zones section). The security system will retain this in for ma tion in its memory

and chirp four or five times each time it is dis armed, until the next time that the

ignition is turned on.