APRILIA RS 125 マニュアル
TECHNICAL INFORMATION
2 - 19
RS125
BATTERY VOLTAGE
When the Clock readout is displayed, a
brief press of the MODE button will turn
on the battery icon and battery charge
display.
When battery voltage is outside the correct
operating range (10 to 16 V), the
flashing “
When the Clock readout is displayed, a
brief press of the MODE button will turn
on the battery icon and battery charge
display.
When battery voltage is outside the correct
operating range (10 to 16 V), the
flashing “
” symbols is displayed.
SERVICE INTERVAL
When the next service interval is drawing near, an icon
representing an open-end spanner will flash for five seconds
on the display as a reminder.
Upon reaching the service interval, the icon stays on
permanently.
First service reminder 1.000 km (625 mi).
Afterwards: every 4000 Km (1.7 mi)
The icon will be turned off during the service procedure at an
aprilia Dealer or Authorised Service Centre.
When the next service interval is drawing near, an icon
representing an open-end spanner will flash for five seconds
on the display as a reminder.
Upon reaching the service interval, the icon stays on
permanently.
First service reminder 1.000 km (625 mi).
Afterwards: every 4000 Km (1.7 mi)
The icon will be turned off during the service procedure at an
aprilia Dealer or Authorised Service Centre.
HOW TO SELECT KM OR MILES
Upon power-on with the key set to “ ”, hold down the
MODE button for more than ten seconds to change the unit
of measurement from kilometres (Km) to miles (Mi);
selection applies to both odometer (ODO) and speedometer.
Readout remains blank for five seconds and then the unit of
measurement begins to flash.
If the MODE button is released before 10 seconds, the
current unit of measurement is retained.
Upon power-on with the key set to “ ”, hold down the
MODE button for more than ten seconds to change the unit
of measurement from kilometres (Km) to miles (Mi);
selection applies to both odometer (ODO) and speedometer.
Readout remains blank for five seconds and then the unit of
measurement begins to flash.
If the MODE button is released before 10 seconds, the
current unit of measurement is retained.