Approach Tech IP Camera LC-7314 ユーザーズマニュアル

 

98

 

 

The Ethernet interface on the IP Camera has a default IP address (192.168.1.168) that most likely 

needs to be changed to make it work on your local network. You need to acquire a unique IP 

address (ask your network administrator). For the initial setting of the IP address the IP Camera 

needs to be connected to the same network segment as your client, and the IP address can then be 

configured by using a combination of ARP and ping command.  

 

Use any of the following ways to set the IP address within thirty seconds after booting the IP 

Camera (re-cycle the power). Setting IP using the method below can only be done on the Ethernet 

interface.  

 

ARP and ping from Windows or MS-DOS:  

The user can open the PC's MS-DOS windows from the WINDOWS 98 operation system, or open 

the PC's Command Prompt windows from either the WINDOWS 2000 or the WINDOWS XP 

operation system. 

1. 

Start a DOS prompt window  

2. 

Type the following in 30 seconds after the booting: 

arp -s <IP address> <Ethernet address> 

[or arp -s <IP address> < MAC address>] 

ping <IP address> 

 

Example: 

arp -s 192.168.1.100 00-0C-0C-00-00-01 

ping 192.168.1.100  

The IP address now is: 192.168.1.100.