AMX NXC-M/ME/MPE ユーザーズマニュアル

The Program Port DIP switch is located at the front of the Master Cards. For Modules, you must 

remove the front panel to access the DIP Switch.

Use this DIP switch to set the baud rate for the Program Port, according to the settings shown in the 

following table. Make sure the baud rate you set matches the baud rate on your PC's COM port 

before programming the Master Card. By default, the baud rate is set to 38,400 (bps). Note the 

orientation of the DIP Switch and the ON position label. 

Input LED

Yellow LED blinks when the Master Card receives data from button 
pushes, strings, commands, channel levels, etc.

Front Panel LEDs - 
blink patterns

These LEDs also display special blink patterns when a mode is activated. 
See the Modes and front panel LED blink patterns section on page 5 for 
details.

Program Port DIP Switch

8-position DIP switch located behind the front panel for setting the baud 
rate for the Program port. The baud rate settings are 9600, 38,400 
(default), 57,600 and 115,200 (bps). See the Program Port DIP switch - 
baud rate settings section on page 2 for details.

PWR connector

2-pin (male) green captive-wire connector for 12 VDC power supply

PROGRAM port

5-pin (male) gray connector for system programming and diagnostics. 
There is a Program port located on the front and rear of the Master Cards 
for easy access. Because these ports share the same circuitry, you 
should never use both ports at the same time. Doing so will result in com-
munication and/or programming errors.

ICSNet connectors

Two RJ-45 connectors that provide power (500 mA) and data to external 
ICSNet devices

ICSNet LEDs

Green LEDs that light when sending/receiving data on that port.

ICSHub In/Out connectors

Two RJ-45 connectors that provide data to other Hubs connected to the 
Master Card

ICSHub IN/OUT LEDs

Yellow LEDs that light when sending/ receiving data on that port.

AXlink LED

Green LED shows AXlink/NetLink data activity

Enclosure

Metal with black matte finish

Front Faceplate

Plastic gray with translucent viewing window

Dimensions (HWD):

Card(s)

1.5" x 5.0" x 8.8" (45 mm x 127 mm x 224 mm)

Module

5.0" x 4.8" x 8.5" (127 mm x 121.9 mm x 215.9 mm)

Optional accessories

• 12 VDC power supply (PSN 6.5, PSN 2.8)

• AC-RK Accessory Rack Kit (Module)