Ameriphone RC-100 ユーザーズマニュアル
CHAPTER 4
(CONTINUED)
(CONTINUED)
You may set up the
DIALOGUE RC
in the
following manner to better suit your needs.
Setting the Scan Function
If you have
DIALOGUE RC
–100:
Only the first six numbers in the memory are
automatically scanned. It stops at each mem-
ory location for 5 seconds to allow you to
select.
automatically scanned. It stops at each mem-
ory location for 5 seconds to allow you to
select.
To turn scan function off (or on):
1. Press PROGRAM.
2. Press 0 on the keypad to turn it off;
2. Press 0 on the keypad to turn it off;
or press 1 key on the keypad to turn it on.
3. Press SCAN button.
If you have
DIALOGUE RC
–200:
All memory locations with numbers stored are
automatically scanned. The scan rate deter-
mines how long the
automatically scanned. The scan rate deter-
mines how long the
DIALOGUE RC
–200
pauses at each memory location before mov-
ing on to the next one.
ing on to the next one.
To turn scan function on or off:
1. Press
PROGRAM.
VOL
PROG
SCAN
MUT
HEAD
MIC
Key Entered
Length of Pause at Each
Location in Seconds
Scan Function Off
5
4.5
4
3.5
3
2.5
2
1.5
1
4.5
4
3.5
3
2.5
2
1.5
1
Figure 7
5
Figure 6
2. Using chart, select length of pause
and press the corresponding digit on
keypad.
keypad.
To turn Voice Activation on (or off)
(RC–200 only):
(RC–200 only):
1. Press PROGRAM.
2. Press MUTE button twice. The MUTE
2. Press MUTE button twice. The MUTE
indicator flashes once, and the RC-
200 emits four beeps to confirm that
Voice Activation has been turned on.
200 emits four beeps to confirm that
Voice Activation has been turned on.
3. To turn it off, repeat steps 1 and 2.
This command is confirmed by four
beeps.
beeps.
To turn the Unanswered Call Indicator
(RC-200) feature off (or on):
(RC-200) feature off (or on):
1. Press PROGRAM.
2. Press HEADSET button twice.
2. Press HEADSET button twice.
(Emits four beeps to confirm command).
3. To turn it on again, repeat steps 1
and 2, and the HEADSET indicator
flashes once.
flashes once.
To turn the Voice Mail Indicator feature
on (or off), (RC–200 only):
on (or off), (RC–200 only):
1. Press PROGRAM.
2. Press FLASH/PAUSE button twice.
2. Press FLASH/PAUSE button twice.
RC–200 emits four beeps and the
FLASH/PAUSE indicator flashes
once.
FLASH/PAUSE indicator flashes
once.
3. To turn it off again, repeat steps 1
and 2, and the FLASH/PAUSE
indicator does not flash.
indicator does not flash.
To turn the Remote Flash feature on (or
off) (RC–200 only):
off) (RC–200 only):
1. Slide remote flash switch to "On" (or
"Off") position.
3. Press SCAN
button.
Figure 8
VOL
PROG
SCAN
MUTE
HEADSET
MIC