Alvarion BREEZEACCESS SW VERSION 5.1 ユーザーズマニュアル
Menus and Parameters
Operation and Administration
163
The default selection is From Both Ethernet and Wireless Link.
CAUTION
Be careful not to block your access to the unit. For example, if you manage an SU via the wireless
link, setting the Access to Network Management parameter to From Ethernet Only completely
blocks your management access to the unit. In this case, a technician may be required to change
the settings at the user's site.
link, setting the Access to Network Management parameter to From Ethernet Only completely
blocks your management access to the unit. In this case, a technician may be required to change
the settings at the user's site.
4.2.6.3.2 Network Management Filtering
The Network Management Filtering option enables or disables the IP address
based management filtering. If management filtering is enabled, the unit can only
be managed by stations with IP addresses matching one of the entries in either
the Network Management IP Addresses list or in the Network Management IP
Address Ranges list, described below, and that are connected to the unit via the
defined port(s). The following options are available:
based management filtering. If management filtering is enabled, the unit can only
be managed by stations with IP addresses matching one of the entries in either
the Network Management IP Addresses list or in the Network Management IP
Address Ranges list, described below, and that are connected to the unit via the
defined port(s). The following options are available:
Disable: No IP address based filtering is configured.
Activate IP Filter on Ethernet Port: Applicable only if the Access to Network
Management parameter is configured to either From Ethernet Only or From
Both Ethernet and Wireless Link. The unit can be managed from the Ethernet
port only by stations with IP addresses matching one of the entries in the Set
Network Management IP Addresses parameter. If the Access to Network
Management parameter is configured to From Both Ethernet and Wireless
Link then no IP address based filtering is configured for the wireless port.
Both Ethernet and Wireless Link. The unit can be managed from the Ethernet
port only by stations with IP addresses matching one of the entries in the Set
Network Management IP Addresses parameter. If the Access to Network
Management parameter is configured to From Both Ethernet and Wireless
Link then no IP address based filtering is configured for the wireless port.
Activate IP Filter on Wireless Link Port: Applicable only if the Access to
Network Management parameter is configured to either From Wireless Link
Only or From Both Ethernet and Wireless Link. The unit can be managed
from the wireless port only by stations with IP addresses matching one of the
entries in the Set Network Management IP Addresses parameter. If the Access
to Network Management parameter is configured to From Both Ethernet and
Wireless Link then no IP address based filtering is configured for the Ethernet
port.
Only or From Both Ethernet and Wireless Link. The unit can be managed
from the wireless port only by stations with IP addresses matching one of the
entries in the Set Network Management IP Addresses parameter. If the Access
to Network Management parameter is configured to From Both Ethernet and
Wireless Link then no IP address based filtering is configured for the Ethernet
port.
Activate IP filter on Both Ethernet and Wireless Link Ports: Applicable to
all options of the Access to Network Management parameter. The unit can be
managed from the port(s) defined by the Access to Network Management
parameter only by stations with IP addresses matching one of the entries in
the Set Network Management IP Addresses parameter.
managed from the port(s) defined by the Access to Network Management
parameter only by stations with IP addresses matching one of the entries in
the Set Network Management IP Addresses parameter.
The default selection is Disable.