ADIC Landscape Lighting 5.1 ユーザーズマニュアル

VolServ Version 5.1 — 6-00572-01

Page 3 of 14

The following table describes known problems in this release.

The following libraries are supported in this release.

AIT is not currently supported as a pre-defined media type. At this time, an AIT library 
must be configured as an 8mm library.

In previous releases of VolServ, AML libraries with AIT-1 and/or AIT-2 drives may have used either one 
of the following DAS/AMU drive type designators:

• DC = AIT-1 and/or AIT-2 

• DM = AIT-1 and/or AIT-2

In VolServ release 5.1, due to a change in the AMU software, AML libraries with AIT-1 and/or AIT-2 

drives now use the following DAS/AMU drive type designators:

• DC = AIT-3

• DM = AIT-1 and/or AIT-2

IRIX 

4365

(07719)

When the operator’s console display goes down, the 

change archive 

parameters cannot be used to redisplay the console. 

Workaround: Select the specific library to be reconfigured, select <OK> to bring 
down the library, and then select <Done> so the operator’s console for that archive 
will reappear.

All

3669

(07723)

Library console does not emit a beep each time status is returned to it. 

4239

(07717)

The 

vsamlconfig

 command cannot handle hex numbers for drive slots that are 

printed from the AMU. 

Workaround: Configure the archive as a Scalar DLC archive.

4242

(07724)

If changing the AML configuration after initially configuring the library, the modified 
AMU information is unable to be uploaded to VolServ without deleting and 
recreating the library. 

Workaround: Configure the archive as a Scalar DLC archive.

4323

(11773)

Mixed media imports do not work for SCSI libraries.

6378

(08529)

Unable to mount tapes after recovery of offline robot.

6379

(11035)

If VolServ is started when the Scalar 1000 or the Scalar 10k archives are offline, 
the AMTask will not start. 

Workaround: Place the archives in an online state and cycle VolServ to get the 
AMTask running.