Dynex DX-G1113 ユーザーズマニュアル
Installing your car stereo
19
Buick
Skylark 1990-1995
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Pull out on the ashtray, then remove the two exposed screws inside the ashtray
2 Pull out on the ashtray, then remove the two exposed screws inside the ashtray
compartment.
3 Remove the two screws that secure the ashtray and lower edge of the dash trim bezel.
4 Using a panel removal tool, pry out on the trim bezel, then remove it.
4 Using a panel removal tool, pry out on the trim bezel, then remove it.
5 Remove two nuts from the bottom of the factory head unit, then remove it.
6 Remove the hardware that secures the factory mounting brackets to the factory head
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
7 Go to “Completing the installation” on page 76.
2
S10 shown
as example
as example
DX-G1113.fm Page 19 Wednesday, August 16, 2006 3:38 PM