Dynex DX-G1113 ユーザーズマニュアル
Installing your car stereo
37
Chevrolet
Celebrity 1984-1989
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the glove box compartment, by pressing on the clip on the bottom of the
2 Remove the glove box compartment, by pressing on the clip on the bottom of the
glove box lines and removing the six exposed nuts above the opening.
3 Remove the six screws below the steering column.
4 Remove the headlight knob by pressing the clip on the back of the knob and removing
4 Remove the headlight knob by pressing the clip on the back of the knob and removing
the nut.
5 Remove the cigarette lighter, then disconnect the wiring.
6 Grasp the lighter socket, unscrew the brass nut on the back of the lighter, then remove
6 Grasp the lighter socket, unscrew the brass nut on the back of the lighter, then remove
the socket.
7 Remove the dash trim bezel, then disconnect the wiring.
8 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
9 Go to “Completing the installation” on page 76.
2
S10 shown
as example
as example
DX-G1113.fm Page 37 Wednesday, August 16, 2006 3:38 PM