Dynex DX-G1113 ユーザーズマニュアル
Installing your car stereo
67
Pontiac
Grand Am 1992-1995
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the six 7 mm hex-head screws from the driver’s side knee bolster panel, then
2 Remove the six 7 mm hex-head screws from the driver’s side knee bolster panel, then
lower the panel.
3 Remove the four Phillips screws from the glove box and cup holder assembly.
4 Remove the one 7 mm hex-head screw from the left corner of the dash trim bezel.
5 Loosen two 10 mm nuts from the top of the factory head unit, slide the unit out, then
4 Remove the one 7 mm hex-head screw from the left corner of the dash trim bezel.
5 Loosen two 10 mm nuts from the top of the factory head unit, slide the unit out, then
disconnect the wiring.
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
7 Go to “Completing the installation” on page 76.
2
S10 shown
as example
as example
DX-G1113.fm Page 67 Wednesday, August 16, 2006 3:38 PM