Dynex DX-G1113 ユーザーズマニュアル
Installing your car stereo
9
Buick
Century 1982-1996
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four screws from the top inside edge of the dash trim bezel.
3 Remove the five screws from both sides of the steering column.
4 Remove the three Phillips screws that secure the rocker-switch housing, then lift the
2 Remove the four screws from the top inside edge of the dash trim bezel.
3 Remove the five screws from both sides of the steering column.
4 Remove the three Phillips screws that secure the rocker-switch housing, then lift the
housing out.
5 Remove the bezel.
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit.
7 Remove and retain the brackets.
8 Go to “Completing the installation” on page 76.
2
S10 shown
as example
as example
DX-G1113.fm Page 9 Wednesday, August 16, 2006 3:38 PM