Digidesign Control 24 ユーザーズマニュアル

To configure Automation Write On Stop modes to 
remain enabled after an automation pass:

■

While holding CTL/CLUTCH and 

OPT(ALT)/ALL, press the START, END, or ALL 
switch in the WRITE AUTOMATION TO section. 
The switch lights to indicate that Write on Stop 
will remain enabled.

Automating Plug-Ins

Control|24 supports Pro Tools features for the 
writing of dynamic automation of plug-ins.

To record dynamic automation of a plug-in:

1  

Use the AUTOMATION ENABLE switches to 

make sure that Plug-In Automation is globally 
record-enabled. 

2  

Choose an automation mode for the channel 

you wish to automate by doing one of the fol-
lowing:

• Pressing the channel’s AUTO switch to step 

through automation modes.

– or –

• Pressing the channel’s AUTO switch, while 

pressing a master AUTOMATION MODE 
switch. 

3  

Display the plug-in’s parameters by pressing 

the channel’s INSERT, EQ, or DYN switch, fol-
lowed by INSERTS/PARAM, to place Control|24 
into Parameters mode. In this mode, the encod-
ers can be used to enter and record parameter 
automation data. 

4  

Press PLAY. Automation recording begins, and 

adjustments to the encoder knobs will be re-
corded as automation data. 

5  

Rotate the channel encoder to write automa-

tion moves. Following all Pro Tools settings for 
touch time-out and thinning, automation will 
be recorded to the plug-in automation playlist. 

6  

You can punch-out of automation recording 

at any time by pressing the appropriate AUTO-
MATION ENABLE switch. 

Arming and Disarming Plug-In 
Parameter Automation

In plug-ins, parameters must be individually en-
abled for automation recording by selecting 
each from within the Plug-In Automation win-
dow. 

Control|24 provides direct and immediate ac-
cess to plug-in automation enabling in the AU-
TOMATION section. 

To enable automation for any parameter: 

1  

Select the desired plug-in to make it the con-

troller focus. 

2  

Press the AUTO/SELECT switch.

3  

Press the encoder switches below the parame-

ter names in the scribble strips that you want to 
automate. The encoder switch LEDs will light, 
and “AUTO” followed by “ON” will flash briefly 
in place of the parameter name in the scribble 
strips. 

4  

Begin automation recording and adjust pa-

rameters as needed.