Digidesign Control 24 ユーザーズマニュアル

Cycle Test Mode

Cycle test mode places the faders on Control|24 
in a test mode where the faders cycle, lock-step, 
from the bottom of the fader throw to the top in 
a continuos cycle. The speed at which the faders 
cycle is determined by adjusting the scrub/shut-
tle wheel. 

When “Cycl” fader test mode is engaged:

• The encoder switch LED located below the 

scribble strip which shows “Cycl” will light 
solid indicating that this is the chosen test 
mode.

• All other display test menu items shown on 

the scribble strips as well as their associated 
flashing encoder switch LEDs, will remain vis-
ible in this test mode. 

• The scribble strip displays will toggle back and 

forth between the cycle values, which allows 
you to select another display test mode with-
out the need to first “Exit” this mode.

• The fader position value will be shown in 

these scribble strips and will be updated in 
real-time as the faders “cycle.” Values will 
range from off (value of “0000”) to full-on 
(value of “1023”).

• Rotate the scrub/shuttle wheel to adjust the 

cycle speed that the faders use. Turning the 
wheel to the left decreases the speed while ro-
tating the wheel to the right increases the 
speed.

• Press the flashing encoder switch located be-

low the scribble strip showing another test 
mode to simultaneously disengage the fader 
cycle test mode and enter the newly selected 
mode. The encoder switch LED for the new 
choice will light solid while the other choices 
flash.

• When finished, press EXIT.

Sine Test Mode

Sine test mode places the faders on Control|24 
in a test mode where the faders cycle, in a sine 
wave shape, from the bottom of the fader throw 
to the top. The speed at which the faders cycle is 
determined by adjusting the scrub/shuttle 
wheel. 

When “Sine” Fader Test Mode is Engaged:

• The encoder switch LED located below the 

scribble strip which shows “Sine” will light 
solid indicating that this is the chosen test 
mode.

• All other display test menu items shown on 

the scribble strips as well as their associated 
flashing encoder switch LEDs, will remain vis-
ible in this test mode. The scribble strip dis-
plays will toggle back and forth between the 
sine cycle values, to allow you to select an-
other display test mode without the need to 
first “Exit” this mode.

• The fader position value will be shown in 

these scribble strips and will be updated in 
real-time as the faders cycle in sine mode. Val-
ues will range from off (value of “0000”) to 
full-on (value of “1023”).

• Rotate the scrub/shuttle wheel to adjust the 

cycle speed that the faders use. Turning the 
wheel to the left decreases the speed while ro-
tating the wheel to the right increases the 
speed.

• Press EXIT, or press the flashing encoder 

switch located below the scribble strip show-
ing another test mode to simultaneously dis-
engage the fader sine test mode and enter the 
newly selected mode. The encoder switch LED 
for the new choice will light solid while the 
other choices flash.