Digidesign Control 24 ユーザーズマニュアル

To make the same input assignment to all 
channels simultaneously:

■

Press APPLY TO ALL CHANNELS or 

OPT(ALT)/ALL while confirming your selection. 

Using the above procedure to select “none” (in-
dicated by “–” in the scribble strip) is a quick 
and easy way to remove the input settings on all 
tracks. 

To make the same input assignment to selected 
channels only:

■

Press APPLY TO ALL SELECTED CHANNELS or 

OPT(ALT)/ALL+SHIFT/ADD while performing 
step 4 above. 

Assigning Inputs in Sessions with 
Multiple Plug-In Outputs

In sessions with plug-ins that have multiple out-
puts, the outputs of those plug-ins are available 
as inputs in other audio and Auxiliary Input 
tracks. These appear as a third category of in-
puts, labelled plug-ins. 

To assign an input from a plug-in output:

1  

Press the ASSIGN switch in the Assignment 

section.

2  

Press the INPUT switch.

3  

Turn the encoder knob on an audio or Auxil-

iary Input track to display the plug-in output 
you want to select as an input. (Plug-in outputs 
appear after Interface and Bus inputs in the list.)

4  

Press the flashing ASSIGN switch to confirm 

the assignment. 

Displaying Input Assignments:

You can easily check input or output assignment 
at any time. 

When viewing input, output, or insert routing, 
the currently selected assignments will be indi-
cated by a “>“symbol in front of the assignment 
name.

To temporarily display input assignment:

■

Press INPUT. The currently assigned input set-

tings will be displayed in each channel’s scribble 
strip for as long as you press INPUT.

Assigning Outputs

To assign an audio channel output: 

1  

Press the ASSIGN switch in the Assignment 

section. 

2  

Press the OUTPUT switch. 

3  

Turn the encoder knob to scroll through the 

list of outputs. 

4  

Press the flashing switch directly below the 

data encoder knob to confirm your selection.

5  

Adjust the data encoder knobs on any other 

tracks for which you would like to make output 
assignments. Press the flashing switches directly 
below the data encoder knobs to confirm any 
other choices.

6  

Press ASSIGN or ESC/CANCEL to leave Output 

Assignment mode. 

Your output selections will not be saved if you 
press the ESC/CANCEL switch without first con-
firming your selections by pressing either the 
master ASSIGN switch or the flashing switch di-
rectly below the data encoder knob on each se-
lected track.