Delta Tau GEO BRICK DRIVE ユーザーズマニュアル
Geo Brick Drive User Manual
Pinouts and Software Setup
26
PINOUTS AND SOFTWARE SETUP
WARNING
Installation of electrical equipment is subject to many regulations
including national, state, local, and industry guidelines and rules.
The following are general recommendations but it is important
that the integration be carried out in accordance with all
regulations pertaining to the installation.
including national, state, local, and industry guidelines and rules.
The following are general recommendations but it is important
that the integration be carried out in accordance with all
regulations pertaining to the installation.
J1: Main Bus Power Input
J1 is used to bring the main AC/DC bus power into the Geo Brick Drive.
J1: Molex 4-pin Male
Mating: Molex 4-pin Female
L3
L2
L1
GND
DATA SYSTEMS,
INC.
INC.
DELTA TAU
B
Pin #
Symbol
Function
Three Phase
Single Phase
DC
1
GND
Ground
2
L1
Input
AC Line Phase 1
Not Connected
Not Connected
3
L2
Input
AC Line Phase 2
Neutral
DC- Return
4
L3
Input
AC Line Phase 3
Line
DC+
Molex Mating Connector p/n: 0428160412
Molex Pins p/n : 0428150031
Molex Crimper Tool p/n: 63811-1500
Delta Tau Mating Connector p/n: 014-H00F04-049 (for internal use)
Delta Tau Pins p/n: 014-042815-031 (for internal use)
Molex Pins p/n : 0428150031
Molex Crimper Tool p/n: 63811-1500
Delta Tau Mating Connector p/n: 014-H00F04-049 (for internal use)
Delta Tau Pins p/n: 014-042815-031 (for internal use)
Note
In single phase operation, use L2 and L3, and leave L1 floating.
In DC mode operation, use L3 for DC+ and L2 for DC return, and
leave L1 floating.
In DC mode operation, use L3 for DC+ and L2 for DC return, and
leave L1 floating.