BMW 2011 Z4 sDrive35is オーナーマニュアル

light is switched on, the condensation evapo‐
rates after a short time. The headlamp glasses
do not need to be changed.
If there is a large amount of moisture, e.g., water
droplets form in the lamp, have the lamp
checked by your service center.

Because of the long life of these bulbs, the like‐
lihood of failure is very low. Switching the lamps
on and off frequently shortens their life.

Do not perform work/bulb replacement on
xenon headlamps

Have any work on the xenon lighting system, in‐
cluding bulb replacement, performed only by a
service center.
Due to the high voltage present in the system,
there is the danger of fatal injuries if work is car‐
ried out improperly.◀

H8 bulb, 35 watts

1.

Switch off the lamps and take the remote
control out of the ignition lock.

2.

Turn the upper access cover to the left and
remove it, see arrow.

3.

Turn the bulb by approx. 90°, see arrow 1,
and pull it out, see arrow 2.

4.

Disconnect the plug, change the bulb and
reconnect the plug.

5.

Insert the bulb and turn it until it stops.

6.

Screw on the access cover tightly by turning
it to the right.

Attach the access cover carefully
Be careful when attaching the access

cover; otherwise, it may leak, causing damage to
the headlamp system.◀

P24W bulb, 24 watt

1.

Turn the wheel outwards.

2.

Turn both locks in the wheel house to the left
and remove the cover.

Seite 205

205

Online Edition for Part no. 01 41 2 604 231 - 03 10 500