Bushnell HuntTrack オーナーマニュアル

3

•  Open battery cover and insert 3 AAA batteries (Fig 1, 

pg 4). Record the serial # inside-you’ll need it later to
register your HuntTrack online. Close the cover.

•  Go  outdoors.  HOLD  POWER  (1)  (keep  the  button

pressed)  until  the  display  comes  on.  Wait  for  GPS
satellite lock (icon stops blinking) (11). This may take
a few minutes after the first power-up in a new area.

•  Press SETUP (4). Press MARK (2), then press the TRIP 

(3)  or  SETUP  button  to  set  the  Hour  for  your  area

(Fig. 2). Press the MARK button to return to the Setup
screen.

•  To change the time and temp/distance formats, press

SETUP to select “12h” or “

0

F/yd”, then press MARK to

set to “24h” or “

0

C/m”. (Fig. 3). The arrow’s function is

explained on page 6. Press POWER to exit Setup.

•  Press  POWER  to  select  one  of  five  Location  icons/

or  5-20  numbers  (6)  (Tent,  Truck,  Tree,  Treestand,
Deer,  #1-20).  While  standing  at  the  Location  you
want  to  mark,  HOLD  MARK  to  save  its  position  in
the  HuntTrack’s  memory  (the  display  will  change
as  shown)  (Fig. 4). You  can  now  turn  the  power  off
(HOLD POWER) and leave the location.

•  To  return  to  the  location  you  marked,  turn  the

HuntTrack on. Make sure the same icon or # you used
to  mark  the  location  is  shown  (if  not,  press  POWER
to  select  it). The  display  indicates  the  direction  and
distance  back  to  the  location  (Fig. 5).  Move  in  the
direction  of  the  arrow,  watching  for  the  distance  to
decrease.  When  you  reach  the  location,  the “Mark”
icon will flash in the center of the display.