Bradley Smoker MG-2/BIR3 ユーザーズマニュアル
Express® Lavatory System - MG Series with Battery Infrared Control
MG-2/BIR3
MG-2/BIR3
Installation Instructions
2
8/23/07
Bradley Corporation • 215-1510 Rev. D; ECN 07-815
Pre-Installation Information
Barrier-free and ADA compliant - standard height mounting
The MG-2/BIR3 Express® Lavatory System with Battery Infrared Control must have a rim height no
higher than 34" above finished floor to be compliant with Americans with Disabilities Act (ADA).
When mounted at 34" rim height, the MG-2/BIR3 Express® meets ADA, ANSI and UFAS
requirements for barrier-free clearances, reaches and controls. Always check local codes and
ordinances for compliance.
higher than 34" above finished floor to be compliant with Americans with Disabilities Act (ADA).
When mounted at 34" rim height, the MG-2/BIR3 Express® meets ADA, ANSI and UFAS
requirements for barrier-free clearances, reaches and controls. Always check local codes and
ordinances for compliance.
Barrier-free and ADA compliant - juvenile height mounting
The MG-2/BIR3 Express® Lavatory System with Battery Infrared Control must have a rim height no
higher than 30" above finished floor to be compliant with Americans with Disabilities Act (ADA)
Accessibility Guidelines for Buildings and Facilities: Building Elements Designed for Children's
Use; Final Rule.
higher than 30" above finished floor to be compliant with Americans with Disabilities Act (ADA)
Accessibility Guidelines for Buildings and Facilities: Building Elements Designed for Children's
Use; Final Rule.
Texas Accessibility Standards compliant:
The MG-2/BIR3 Express® Lavatory System with Battery Infrared Control meets Texas Accessibility
standards (TAS) for barrier-free clearances, reaches and controls. Always check local codes and
ordinances for compliance.
standards (TAS) for barrier-free clearances, reaches and controls. Always check local codes and
ordinances for compliance.
Infrared sensor and solenoid
Each sprayhead is controlled by a separate sensor and solenoid valve, enabling each user to activate a
single flow of water. Each valve uses less than half the maximum of hot water allowed by the
ANSI/ASHRAE/IES 90A-1980 Standard.
single flow of water. Each valve uses less than half the maximum of hot water allowed by the
ANSI/ASHRAE/IES 90A-1980 Standard.
Supplies required for installation:
• (8) 3/8" wall anchors, bolts and washers to mount frame and bowl
to wall (minimum pull-out rating of 1,000 lbs.)
• 1/2" NPT hot and cold supply piping and 1-1/2" NPT drain piping
• 1/2" NPT street elbow
• 1/2" NPT street elbow