Samsung ML-2551N ユーザーズマニュアル
U
SING
THE
C
ONTROL
P
ANEL
3.15
3
3
Job Time Out
You can set the time length the printer waits
before printing the last page of a print job
that does not end with a command to print
the page.
before printing the last page of a print job
that does not end with a command to print
the page.
When a print time-out occurs, the printer
prints the page in the print buffer.
prints the page in the print buffer.
RS-232C
This item is only available if the optional
serial interface card is installed in your
printer. For details, see page F.6.
serial interface card is installed in your
printer. For details, see page F.6.
• Baud Rate: Lets you select the rate at
which data is being sent to or from your
computer using the serial communication.
Note that using a setting higher than
19200 bps with the COM port may cause
unexpected errors in DOS mode.
computer using the serial communication.
Note that using a setting higher than
19200 bps with the COM port may cause
unexpected errors in DOS mode.
• Robust XON: Turns use of XON/OFF of
serial communication control on or off.
When this item is set to On, the printer
sends a continuous stream of XONs to the
computer to indicate that the serial port is
ready to receive more data.
When this item is set to On, the printer
sends a continuous stream of XONs to the
computer to indicate that the serial port is
ready to receive more data.
Maintenance
This item allows you to maintain the toner
cartridge.
cartridge.
• OPC Cleaning: Cleans the OPC drum of
the cartridge and produces a cleaning
sheet with toner debris on it.
sheet with toner debris on it.
• Fuser Cleaning: Cleans the fuser unit
inside of the printer and produces a
cleaning sheet with toner debris on it.
cleaning sheet with toner debris on it.
• Remain Toner: This item allows you to
check how much toner are left in the
cartridge.
cartridge.
Item
Explanation
Values: 0 ~ 300 sec *15 sec