Bosch Appliances Home Security System 3.5 ユーザーズマニュアル
Bosch Security Systems | 2011-02
2011-02 | Installation and User Instructions | 5 | Call Stations
en | 241
21.2
Controls, connectors and
indicators
indicators
Back-up supply/Control inputs - Besides
powering the remote call station kit via the
system network connector (X908), it can also be
powered externally from a back-up power
supply (see section 21.2.1). The connector also
provides two input contact pairs.
system network connector (X908), it can also be
powered externally from a back-up power
supply (see section 21.2.1). The connector also
provides two input contact pairs.
X908
System bus - An RJ45 connector to connect
the remote call station kit to a call station
interface via a straight Cat-5 cable.
interface via a straight Cat-5 cable.
X1
Keypad interface - The keypad interface is
used to connect up to 16 keypads to the remote
call station kit (see section 21.2.6).
call station kit (see section 21.2.6).
X300
Microphone type selector - The
microphone type selector is used to select either
“dynamic” or “electret condenser” microphone
types.
“dynamic” or “electret condenser” microphone
types.
X301
Microphone - The microphone input is used
to connect a microphone (see section 21.2.3).
X511
External Speaker - The external speaker is
meant for listening to chimes, pre-recorded
messages etc. (see section 21.2.5). Only chimes
and messages activated by a PTT key of the
remote call station or one of its keypads (see
section 47.3.3) are played via the loudspeaker of
the remote call station.
messages etc. (see section 21.2.5). Only chimes
and messages activated by a PTT key of the
remote call station or one of its keypads (see
section 47.3.3) are played via the loudspeaker of
the remote call station.
X501
Headset - The headset connector provides the
possibility to connect a headset to the remote
call station kit (see section 21.2.2).
call station kit (see section 21.2.2).
X107
Control input/outputs - The control input
and five control outputs are used as
replacement for the PTT key and LEDs on the
PRS-CSR Remote Call Station (see section
21.2.4).
replacement for the PTT key and LEDs on the
PRS-CSR Remote Call Station (see section
21.2.4).
Caution
Do not connect the connector X908 to any
Do not connect the connector X908 to any
Telecom or Ethernet network. This connection is
dedicated for PRS-CSI only.
figure 21.2: Component side
8
1.
.
.
.
.
X908
X2
X301
X107
1
6.
.
.
.
.
X511
6
1.
.
.
.
.
X501
6
1.
.
.
.
.
X1
16
15
15
2
1
1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
1
2
2
13
14
14
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
8
7
7
2
1
1
.
.
.
.
.
.
X300
1
3.