Bosch 2000 ユーザーズマニュアル

ページ / 72
2000 Series | Program Entry Guide | 4.0 
Receiver 
EN | 15 
 
 
Bosch Security Systems | 7/05 | 35114F 
 
4.0 Receiver 
4.1 Modem 
Reports 
1 Rcvr Format 
Default: 
Modem
 
Selection: 
Modem, Pulse
 
0 Pulse 
1 Modem 
Set 
Rcvr Format
 to Modem to transmit reports in Modem II format with its advanced reporting capabilities. 
 
 
 
You need firmware revision 8.00 or greater installed in your D6500 Receiver. 
Table 2 shows the reports available. 
The D6500 line card ack tone table must contain “Modem II for D9112.” Refer to the 6500: Line Program Entry 
Guide
Set 
Rcvr Format
 to Pulse to transmit in 4x2 Pulse Format. Be sure to program codes for each report group. Refer 
to the
 Section
 
4.2
 
Pulse Report Groups
Table 2: Modem II Reports Chart 
 
Modem II Report 
Description 
AC FAILURE 
No AC power to system. Control panel runs on battery. 
AC RESTORE 
AC Power is restored to normal. 
ALARM REPORT POINT   
001 (-099) 
Alarm Report from Points 1 to 24 or from an A, B, C, key. Refer to Section 7.0 ABC Keys for 
instructions on setting reports from the keys. 
ALARM REPORT 
RECENT CLOSING  
ID=001 
POINT=001(24) 
If an alarm occurs within 2 minutes of a Closing event, the system sends an Alarm Recent 
Close Report. 
ALARM CROSS POINT   
001 (-099) 
Alarm Report from Points 1 to 24 with point code for Cross or Partner point. 
The ALARM RECENT CLOSE message overrides the ALARM CROSS POINT message. 
The ALARM EXIT ERROR message does not apply to Cross, Partner, Double Knock, or Alarm 
Verification points 
BATTERY LOW 
System battery is low. 
BATTERY MISSING 
System battery is disconnected. Battery must be missing for 60 seconds. 
BATTERY RESTORE 
Missing or low battery is restored. 
CANCEL REPORT  
Cancel Report from keyswitch. 
CANCEL REPORT  ID   
001 (-008) 
Cancel Report with user ID for users 1 to 8.