Bosch 2000 ユーザーズマニュアル

ページ / 72
2000 Series | Program Entry Guide | 10.0 
Address Configuration 
EN | 33 
 
Bosch Security Systems | 7/05 | 35114F 
 
10.0 Address Configuration 
Use the prompts in this group to configure the system 
for devices connected to the data terminal (Terminal 
6). 
 
 
Remember you can only connect four point 
expanders to the data terminal (terminal 6). 
Count Text Keypads with Points as point 
expanders. 
1  Address 1 
 
2  Address 2 
 
3  Address 3 
 
4  Address 4 
 
5  Address 5 
 
6  Address 6 
 
7 Address 7 
 
8  Address 8 
Default: 
Text Keypad (Address 1) 
Not Used (Addresses 2 to 8)
 
Selection:  Not Used 
LED Keypad 
Text Keypad 
Text Keypad with Points* 
RF Point Expander, 8* 
RF Point Expander, 16* 
Point Expander*
 
Not Used 
1 LED 
Keypad 
2 Text 
Keypad 
Text Keypad with Points* 
RF Point Expander, 8* 
RF Point Expander, 16* 
6 Point 
Expander* 
* These selections do not apply to E version control panels. 
E version control panels interpret these selections as 0. 
Enter the type of device connected to the system for 
each address.  
 
 
 
You can only connect four point expanders 
to the system. 
Do not connect more than one device with 
the same address to the control panel. 
Although LED keypads cannot set an address, you 
must enter LED keypad for one address if you are 
going to connect one to the system. Use one 
address for all LED keypads. 
If you are using one text keypad, you must set its 
address to 
Address 1
. If you are using more than 
one text keypad, be sure one keypad has its 
address set to 
Address 1
.
 
 
 
The system stores the master copy of the 
Custom Idle Text, Custom Service Text, 
and Point Text in the text keypad with its 
address set to 1. 
Keypad programming requires a text keypad with 
its address set to 1. You can program from a text 
keypad with its address set to 1, even if you 
change the 
Address 1
 prompt from the default 
text keypad. 
If you are using an RF Point Expander, its address 
must be set for Address 7 or Address 8. If you are 
using two RF Point Expanders, set one for Address 
7 and the other for Address 8.