Bosch 2000 ユーザーズマニュアル

ページ / 72
2000 Series | Program Entry Guide | 15.0 
Passcodes 
EN | 59 
 
Bosch Security Systems | 7/05 | 35114F 
 
15.0 Passcodes 
If you are programming from the keypad, you must 
exit the Programming Mode to program passcodes. 
Use Show User ([6] key) and your installer passcode. 
Follow the instructions in the Security System User Guide
1 Instir Code 
Default: 
654321
 
Selection:  0 to 9, Blank
 
Installers enter this passcode to perform keypad 
programming. They can also use it to perform tests 
and to change passcodes. You cannot use the installer's 
passcode to turn the system off. 
The installer passcode always requires six digits. Even 
when the 
Passcode Length
 prompt is less than six, 
you must enter six digits for this prompt. If you enter 
less than six digits and increase the 
Passcode Length
 
later, the installer code is disabled. 
The D5200 Programmer and remote programmers do 
not let you program the same passcode for the installer 
and a user. The system prevents users changing their 
own passcodes at the keypad from duplicating the 
installer code. However, the system does not prevent 
installers programming from the keypad, from 
programming the same passcode for the installer and a 
user. 
Use the D5200 Programmer or remote programmer to 
fill this prompt with spaces to disable the installer 
passcode. 
2 Passcode Length 
Default: 
3
 
Selection:  3 to 6
 
You can fix the length of user passcodes from three to 
six digits. All passcodes are the same length. 
 
 
 
If you shorten the passcode length after 
entering passcodes, you could possibly 
create duplicate passcodes. For example, 
passcodes 1235 and 1236 both shorten to 
123. If you lengthen passcodes you disable 
some. For example, if you add passcode 
396 and then increase the passcode length 
to four digits, 396 becomes 396F. If you 
cannot enter an F from the keypad, 
passcode 396 is disabled. 
3 Code 8 = Duress 
Default: 
No
 
Selection:  Yes, No
 
0 N
1 Yes 
Setting this prompt to Yes makes the passcode for 
User 8 the duress passcode. The passcode operates 
the system normally and sends a Duress Report to 
the receiver. 
4 Passcode Rquired 
Default: 
No
 
Selection:  Yes, No
 
0 No 
1 Yes 
Setting this prompt to Yes configures the system so 
that users must enter a passcode to turn the system 
on (press [9] and enter passcode). 
Pressing [9] after entering the passcode turns the 
System All On with No Delay (press [9], enter 
passcode, press [9]). 
To turn the system Part On users press [0] and 
then enter a passcode (press [0], enter passcode). 
Pressing [0] after entering the passcode turns the 
System Part On with No Delay (press [0], enter 
passcode, press [0]).