Bosch 2000 ユーザーズマニュアル

2000 Series | Program Entry Guide | 18.0 

Keypad Programming 

EN | 67 

 

Bosch Security Systems | 7/05 | 35114F 

 

18.6 

 

There are four types of custom text you can program for the system. Idle Text, Service Text, ABC Key Text, 
and Point Text.

 

Table 22 describes the procedure for entering custom text at the keypad. You might find it helpful to set up the 
system and try entering the text as shown. Change the default point text for Point 2, 

PT2 PART/DELAY

, to 

GARAGE

.

 

The procedure starts from the first prompt in View Mode. 

Table 22: Entering Custom Text at the Keypad 

 

Procedure 

Display 

1.

 

The first display in View Mode appears. 
The second line shows the factory default for the first prompt in the first group 
(1.1), 0000. 

1.1 
0000 

2.

 

Press the [C] key eleven times to scroll the display to the first prompt in Group 
12. 

12.1 
PT1 FIRE/VERIFY 

3.

 

Press the [*] key to move to the second prompt in Group 12. 

12.2 
2 PART/DELAY 

4.

 

Press the [A] key to enter Modify Mode. 

MOD

 appears to the right of the group 

and prompt numbers. 

A

 replaces the default text in the second line. “A” is the 

first character in the scroll list. 

12.2 MOD 
A 

5.

 

For this example, enter “GARAGE” for the Point 2 custom text. Press the [C] 
key to scroll forward through the scroll list. After the first press, the display 
shows 

B

 in the second line of the display. 

12.2 MOD 
B 

6.

 

Press the [C] key five more times to scroll 

G

 into the display. 

12.2 MOD 
G 

7.

 

Press the [*] key to accept 

G

 and move to the second character position in line 

2. 

A

 appears in the second position. 

12.2 MOD 
GA 

8.

 

Press the [*] key to accept the second letter, “A” , and move to the third 
character position in line 2. 

A

 appears in the third position. 

Press the [*] key until 

R

 appears in the display, then press [*] to accept “R” and 

move to the fourth character position. 

A

 appears in the fourth position. 

Continue using the [C] key and the [*] key to enter GARAGE.  

12.2 MOD 
GAA 

Note:  

E

9.

 

The display now looks like this: 
If your display looks correct (

GARAGE

 appears in the second line), add the “A” 

by  pressing the [*] key to learn how to recover. 

12.2 MOD 
GARAGEA 

10.

 

You can quickly remove the last “A” by pressing any of the numeric keys (0 to 
9) to backspace. 
The display looks like the figure to the right. 
Press the [A] key to exit Modify Mode. 

MOD

 disappears from the display. You 

return to View Mode. Make sure the entry you made is correct before moving to 
the next prompt. 

12.2 MOD  
GARAGE