Bolens 241 サービスマニュアル

NOTE: Stand behind 
the tiller as if you were 
going to operate it. Your 
right hand corresponds 
to the right side of the 
tiller; your left hand 
corresponds to the left 
side of the tiller.

This unit is shipped 
without gasoline or oil 
in the engine. Fill up 
gasoline and oil as 
instructed in the accom-
panying engine manual 
BEFORE operating your 
machine.

NOTE: This operator’s 
manual may cover 
various models of tillers. 
The units illustrated 
may vary slightly from 
your unit. Follow only 
those instructions which 
pertain to your model 
number.

1.  Remove the star handle knobs and carriage bolts from 

the lower handle, Figure 3-1.

Figure 3-2:  Attach and secure upper handle.

Figure 3-3:  Install left side of the tine clutch control.

Figure 3-4:  Hook cable into tine clutch control.

Figure 3-5:  Install right end of tine clutch control.

Figure 3-1: Remove hardware from lower handle.

2.  Position the upper handle onto the lower handle, Step 

A Figure 3-2. Align the holes on lower handle with the 
holes on the upper handle (choose the upper or lower 
holes depending on the desired handle height).

3.  Insert carriage bolts through the holes and secure with 

star knobs, Step B Figure 3-2. Make certain carriage 
bolts are seated securely into one of the two positions 
provided. 

4.  Insert left end of tine clutch control into the hole on the 

left side of the upper handle, Figure 3-3.

5.  Insert the Z-fitting on the clutch cable into the hole 

on the tine clutch control. Hook the “Z” end into the 
opening from the inside to the outside as shown in 
Figure 3-4.

6.  Squeeze the tine clutch control inward. Insert right 

end into the hole on the right side of the upper handle, 
Figure 3-5.