BlueAnt Z9 Bluetooth Headset プリント
Before use, you must pair the headset with your cell phone. Pairing will create a stored connection in
the Z9 and your Bluetooth cell phone. Pairing has to be done only once, when first connecting to a
phone. The Z9 can store pairing information for three (3) different Bluetooth devices.
the Z9 and your Bluetooth cell phone. Pairing has to be done only once, when first connecting to a
phone. The Z9 can store pairing information for three (3) different Bluetooth devices.
Pairing Procedure - This is an example procedure only.
These steps may differ from phone to phone, but the process will be the same.
These steps may differ from phone to phone, but the process will be the same.
1.
First turn the phone OFF and then back ON again to refresh its memory.
2.
Bring the mobile phone to about 30cm from the Z9 Dual Microphone.
3.
Find the Bluetooth menu in your mobile phone. Turn Bluetooth ON.
(Check your mobile phone user guide)
4.
With the Z9 OFF, Press and Hold the MFB for about 6 seconds until the LED flashes Blue.
5.
Your headset is now ready to be discovered by your Bluetooth mobile phone.
6.
Perform Bluetooth a device discovery on your mobile phone to add a new device. It takes a few
seconds to search for and find other Bluetooth devices around you.
7.
When Bluetooth devices are found, the phone will display "BlueAnt Z9". Scroll to it and press OK
to confirm that you want to pair with it.
8.
Enter the Passkey "0000" when your phone prompts you. The phone will now pair with the BlueAnt Z9.
9.
If your Bluetooth phone menu supports it "set as authorized" or "add to trusted devices"
10.
Again select the BlueAnt Z9 to connect with it. OR, Press the MFB to connect with the phone.
BUTTON FUNCTION MATRIX
PAIRING
Note:
Standby Mode
means connected
to a device but not on a call.
Idle Mode
means the Z9 is
ON but not connected to any device
Multiple
button presses
mean click together
Power ON
MFB
3 Seconds
From OFF
Power OFF
MFB
3 Seconds
Idle/Standby
Enter Pairing Mode
MFB
6 Seconds
From OFF
Connect to Device 1
MFB
One Click
Idle
Connect to Device 2
MFB
Two Clicks
Idle
Connect to Device 3
MFB
Three Clicks
Idle
Answer Call
MFB
Click
Ringing
End Call
MFB
3 Seconds
Active Call
Reject Call
MFB
3 Seconds
Ringing
Redial Last Number
VOL
3 Seconds
Standby
Voice Dial Activate
MFB
Click
Standby
Call Conference
VOL
3 Seconds
Active Call
Call Waiting
3 seconds
Active Call
Volume Up
VOL
Click
Active Call
Volume Down
VOL
Click
Active Call
Mute
VOL
3 Seconds
Active Call
Turn LED’s OFF
and
3 Seconds
Idle/Standby
Reset Device
&
MFB
&
Click
Click
Idle
Z9 Function
Button
Time
Status
Disconnect/Tranfer
&
&
Click
Connected
Switch Voice Isolation
between Standard and Max
between Standard and Max
MFB
Active Call